If the mesh for the contact interface is course then Ansys might not recognise the components and hence will fly off into space.Īlso if the contact is initially closed but there is a large gap between the mating components then the components will pass through each other.
#ANSYS WORKBENCH STATIC STRUCTURAL ANALYSIS EXAMPLES FREE#
Please feel free to ask anything I may have missed out on that would aid in my situation and I will respond ASAP. This value (5,934.3 Pa) is from checking the XX component of the imported stress before running any analysis, so other boundary conditions should not be affecting the values. I apologize if I missed out on a lot of crucial information. For example, the maximum stress value for the XX component should be 71,617.6 Pa (from the imported data), but the maximum value displayed in Ansys is 5,934.3 Pa. I hope this is a simple fix and i'm just missing something very simple. Opening ansys workbench Overview: Start > ANSYS Workbench Create Static Structural analysis system. My problem is that when I solve for it, the blocks vanish as if its not there.
I have forces applied onto the blocks as well as frictionless supports for where I cut it in half (due to symmetry) the Ansys Mechanical interface Simple Static Structural Analysis Students. I'm not sure if this is a good method but to save time I am doing this method for now. Opening The ANSYS Workbench Environment From The Program Menu List Open The. Under connections->contacts, I have frictionless contacts between the face of the pipe (target) and the profile of the gripping blocks (contact).Īs for meshing, I'm currently just doing a very coarse test to see if the analysis works. The pipe is clamped by equal and opposite forces being applied on each block. The blocks have a profile on them that grip the pipe. In depth look at each boundary condition with example.
Understanding loads and boundary conditions in CAE. Basically what i'm trying to model is a piece of pipe being clamped by two blocks. Getting familiar with various options available in Ansys Workbench for meshing. My project currently involves analyzing the stresses and deformation occuring on the gripping blocks as well as the piece of pipe. For example, a Static Structural analysis system includes all the cells needed for the analysis, Engineering Data through Results. Any feedback and help is greatly appreciated! Please refer to the photos attached for referral.
First off, I'd like to mention that I am completely unfamiliar with this ANSYS and have been fighting with this program for last 2 and half weeks.
0 kommentar(er)
